Product introduction:

SV Series Pump: The Impeller, pump body, guard board， bracket, and shaft are made of metal material.

SVR Series Pump: The Impeller, pump body, guard board， bracket, and shaft are made of rubber material.

This pump's shaft seal: No shaft seal.

The customized vertical slurry pump is suitable for conveying submerged, abrasive, coarse particles and high concentration slag slurry in metallurgy, mining, coal, electric power, and other industries. Without shaft seal and shaft seal water, it can work normally under the condition of insufficient suction. Such as slurry transportation under immersed liquid in metallurgy, mining, electric power, steel plant, and chemical industry.

Structural Features:

1. The SV slurry pump is a vertical, axial suction, single-stage, single suction, single shell, and centrifugal structure.

2. The materials of flow passage parts can be wear-resistant metal or rubber, and the underwater length can be selected according to the needs of users, with a simple structure and convenient installation and maintenance.

3. The SV series slurry pump is vertically installed, and the working part is submerged below the liquid level, so no shaft seal is needed. If the pump needs to be used for suction, it is recommended to use the SV impeller and guard plate. Some pumps at the inlet end can be equipped with agitators.

4. The pump motor is arranged above the ground, and the working part of the pump is arranged below the liquid level.

5. The pump shaft can be partially extended according to actual conditions to meet different working conditions.

6. The rotor part adopts vinegar lubrication, and an oil nozzle is set up outside for convenient maintenance.

7. The pump is small in size and light in weight, with a simple structure, easy disassembly, simple maintenance for workers, and can save a lot of labor.

8. The over-flow parts of the vertical slurry pump are made of various metal materials, which have good wear resistance and corrosion resistance. The wear rate of the product is low, and as the over-flow parts wear, the overall efficiency declines slowly and smoothly. The rubber pump covers a diameter of 40~150mm.